See post in tech forum
Anyway due to lack of response in the tech forum I decided to strip down forks for service and a good clean out.
Old problem of bottom damper bolt spinning tried all the usual methods, preloading the forks etc no go.
Drilled out bolt with 4mm to 8mm drill in 0.5mm increments. Bolt was like chocolate so came out easily. Out of sh*t. Then removed the dust seal on the fork tube and the dust seal stopper ring. Using fork tube as a sliding hammer oil seal will not budge. Have poured plusgas on top of the seal to see if this will penetrate between the seal. Back in the sh*t, having a brew and a bit of a weep!!
Anyway due to lack of response in the tech forum I decided to strip down forks for service and a good clean out.
Old problem of bottom damper bolt spinning tried all the usual methods, preloading the forks etc no go.
Drilled out bolt with 4mm to 8mm drill in 0.5mm increments. Bolt was like chocolate so came out easily. Out of sh*t. Then removed the dust seal on the fork tube and the dust seal stopper ring. Using fork tube as a sliding hammer oil seal will not budge. Have poured plusgas on top of the seal to see if this will penetrate between the seal. Back in the sh*t, having a brew and a bit of a weep!!